- How to mesure internal temperature when roasting or cooking meat?
1. To achieve the best results, make sure that the meat covers as much of the probe as possible. This ensures the most accurate temperature reading.
2. Insert the probe so that as little metal as possible is visible.
3. General instructions:
- It is important that lean meat is not roasted for too long, whereas fatty cuts can be roasted for a longer amount of time.
- To achieve the best results, maintaining the recommended internal temperature is critical.
- This is important for the tenderness, juiciness, flavor and color of the meat.
- Meat is most succulent when the internal temperature is 58–65oC.
- Bacteria such as salmonella could be found on the surface of a piece of meat, while there are practically sterile bacteriological conditions inside the piece.
- There is no reason to advise against pink colored roast pork loin, tenderloin and sirloin / veal. Chops, medallions and cutlets cut from whole joints may also be red / pink inside.
4. Recommended internal temperatures:
Recommended internal temperature
Pork loin, pork joint
Pork silverside and pork mignon
Minced meat, rolled joint, etc.
Shoulder and shoulder filet
5. Traditional roasting:
- Traditional roasting takes place at 150°C and above.
- Meat with crackling should be roasted at 200ºC.
- More fatty types of meat such as spare ribs should be roasted at 180ºC.
- Lean meat such as Filet Mignon, pork silverside, pork tenderloin, sirloin steak and beef silverside should be roasted at 150–160ºC.
- If possible, place the meat in a cold oven.
- It is better when the piece heats up slowly.
- Fan ovens should be set at approx. 20°C lower than normal ovens with upper and lower heat.
- The internal temperature of the meat may increase 0–5 degrees after the meat is brought out of the oven.
- The higher the oven temperature, the more the internal temperature will rise.
- The exact internal temperature may prove difficult to determine due to a large difference in temperatures throughout the roast / meat. Additionally, it is difficult to hit the coldest point of the roast with the tip of the probe.
6. Slow roasting:
- Slow roasting takes place at 130–150°C.
- The slower heating achieves a more uniform roasting.
- The internal temperature will therefore be easier to measure than in traditional roasting, and it will not increase as much after cooking.
7. Low temperature roasting:
- For low temperature roasting, cooking takes place at 100ºC or lower.
- The oven temperature must be set 20°C higher than the desired internal temperature. However, pork shoulder should be roasted at 125°C.
- The meat becomes more tender and succulent when roasted at a low temperature. Another benefit of low temperature roasting is that it allows for a more accurate measurement of temperature, as there are smaller differences in temperature throughout the roast. The exact placement of the probe is therefore not significant.
- The internal temperature of the meat does not normally increase after the meat is taken out of the oven.
Was this article helpful?